Welding Helmets: Step-By-Step Guide To Use

For a welder, a welding helmets, sometimes called a hood, is an essential piece of personal protective equipment. In the absence of a helmet that protects against UV and infrared rays, the arc can cause eye and skin damage. The welding helmet is one of the most noticeable pieces of safety gear, so wearers can customize their gear.

Welding Helmets – Why They Matter

Due to this need, welding helmets are available in a wide range of colors and graphics. Welders should focus on the helmet’s protective characteristics, as well as the helmet’s comfort while deciding on the right helmet for their needs.

A welding helmet should be lightweight and well-balanced to allow the wearer to work comfortably for a whole day, while protecting their eyes and face from spatter, sparks, and damaging light

Helmets today are far more practical than they were even ten or fifteen years ago. These specialized materials are designed to meet the unique requirements of welders on any job. Even the cheapest products must adhere to stringent global safety requirements.

An auto-darkening welding helmet has a glass that turns dark rapidly to shield the welder’s eyes from damaging UV radiation generated during weldiAuto-adjustablening welding helmets feature adjustable settings to compensate for different types of welding and varying levels of light produced by the welding arc. Following are some recommendations for setting an auto-darkening welding helmet correctly to ensure you receive the maximum level of protection.

A Welding Helmet: How To Use it Properly

STEP 1

First, place the helmet on a clean, dry surface. Make sure the battery is securely fastened to the welding helmet’s front by slinging it over the headband.

STEP 2

The next step is to modify the shield delay timer. It specifies the time it takes for the shield to transition from a darker to a brighter condition. On most auto-darkening welding helmets, the delay can be adjusted by adjusting a switch on the inside of the shield. Depending on the kind of helmet, delay times may be changed between.25 and.35 seconds on a rapid setting and between.6 and.8 seconds on a slower setting. This is more of a personal preference; you should adjust it to your liking.

STEP 3

You can fine-tune the shade using the adjustable knob. It is usually located on the left side of the welding helmet on auto-darkening helmets. This enables the welder to adjust the level of darkness to the type of welding he is doing. Welders should always use the darkest shade indicated for the type of welding they are doing.

STEP 4

Upon ensuring that the welding helmet fits correctly, you should put it on and tighten the headband.

STEP 5

Additionally, you should lower the helmet and adjust the shield’s angle until you can see clearly through it. Make sure the helmet’s auto-darkening shield is properly adjusted before you begin welding. When your welding helmet is adjusted properly, the lens darkens even when you’re not facing the arc. For whatever reason, you should not wear that welding helmet if your glass does not completely darken. 

Leave a Reply

Your email address will not be published.